Manual Reset Lockouts - TriangleTube Instinct Series User's Information Manual

CHAPTER 5 - CTRLMAX OPERATION

5.10.2 Manual Reset Lockouts

Code Lockout Message
E1 Failed Ignition
E2 False Flame
E3 High Boiler Temperature
E5 Blower Speed
E8 Flame Circuit Error
E9 Gas Valve Circuit Error
E13 Reset Limit Reached
E15 Sensor Drift
E16 Supply Sensor Stuck
E17 Return Sensor Stuck
E18 Sensor Failure
E19 Flame Failure During Startup Phase Flame lost after startup
E21 Internal Control Fault
E30 Supply Sensor Shorted
E31 Supply Sensor Open
E43 Return Sensor Shorted
E44 Return Sensor Open
E47 Water Pressure Sensor Error
E80 Return > Supply
E83 Delta T Protection
E87 External Limit Open
22
Description
The burner failed to light after 5 ignition attempts.
Flame detected prior to ignition.
Boiler temperature has reached 210°F [99ºC] or 102°F [39°C].
Blower is not at correct speed or speed signal is not being received by control module.
Flame circuit test failed.
Gas valve circuit test failed.
Resets are limited to 5 every 15 minutes.
Supply or return sensor reading has drifted.
Supply sensor reading is not changing.
Return sensor reading is not changing.
Supply or return sensor reading changed very rapidly.
A / D conversion error.
A short circuit has been detected in the boiler supply temperature sensor circuit.
An open circuit has been detected in the boiler supply temperature sensor circuit.
A short circuit has been detected in the boiler return temperature sensor circuit.
An open circuit has been detected in the boiler return temperature sensor circuit.
Water pressure sensor is disconnected or broken.
Return temperature is higher than supply temperature.
Excessive difference between boiler supply and return temperatures has occured 5 times
An external manual reset limit has opened