CommScope Era M0201AKB_uc Installation Manual page 22

Safely Working with a CAP H
Notice: Corresponding local particularities and regulations must be observed. For national deviations,
6
please refer to the respective documents included in the manual CD that is delivered with the unit.
Note: For a Class B digital device or peripheral:
7
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
•
connected.
Consult the dealer or an experienced RF technician for help
•
Notice: For a Class A digital device or peripheral.
8
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Note: This unit complies with European standard EN60950-1 / EN62368-1.
9
™
CommScope Era High Power Carrier Access Point Installation Guide — Preliminary
Page 18
M0201AKB_uc
© January 2019 CommScope, Inc.