Connecting The Devices; Connecting Fc-101Net - Kramer FC-102Net User Manual

Dual dante interface decoder
Table of Contents

Advertisement

Connecting the Devices

Always switch off the power to each device before connecting it to your
FC-102Net. After connecting your
device.

Connecting FC-101Net

This section describes how to connect FC-101Net.
To connect FC-101Net as illustrated in
1. Connect the Dante PoE RJ-45 port
2. Connect OUT 1
speakers (for example,
Alternatively, you can connect to separate mono outputs.
3. Connect the RS-232 3-pin terminal block connector
a PC).
FC-101Net, FC-102Net – Connecting the Devices
FC-101Net
Figure 3: Connecting to the FC-101Net Rear Panel
Figure
4
5
and OUT 2
6
3-pin terminal block connectors to amplified
Tavor
6-O).
/ FC-102Net, switch on the power to each
3:
to audio streaming via the Ethernet.
8
to a control device (for example,
Kramer Electronics Ltd.
FC-101Net
/
7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FC-102Net and is the answer not in the manual?

This manual is also suitable for:

Fc-101net

Table of Contents