Advertisement
The device is on and in the
Sleeping period: Min Interval.
network
When the reportchange exceeds setting value or the state changes: send a data report according to Min Interval.
First two mins: wake up every 15 seconds to send request.
After two mins: enter sleeping mode and wake up every 15 minutes to send request.
The device is on but not in
Note: Suggest to remove batteries if the device is not used.
the network
Low Voltage Warning
Low Voltage
3.2V
5. Data Report
When the device is turned on, it will immediately send a version package and a data report of water leakages/voltage.
Data will be reported once per hour by default setting.
(If there is special customized inquiry, the setting is changed according to customer requirements.)
Maximum time: 3600s
Minimum time: 3600s
Default reportchange:
Battery ---- 0x01 (0.1V)
R718WB sensor is triggered:
When the R718WB status changes, it will send warning report.
No water leak:0
Water leak:1
The reported data is decoded by the Netvox LoRaWAN Application Command document and
Data report configuration and sending period are as following:
Min Interval
Max Interval
(Unit:second)
(Unit:second)
Any
number
Any
between 1~65535
between 1~65535
Report configuration instruction:
ConfigRe
0x01
portReq
ConfigRe
0x81
portRsp
R718
0x12
ReadCon
WB
figRepor
0x02
tReq
ReadCon
figRepor
0x82
tRsp
Suggest to check the device verification information on the gateway or
consult your platform server provider.
Reportable
Current
Change
Reportable Change
number
Report
Can not be 0.
per Min Interval
MinTim
MaxTime(
BatteryChang
e(2bytes
2bytes
e(1byte
Unit:s)
Unit:s)
Unit:0.1v)
Status(0
x00_suc
cess)
Reserved (9Bytes,Fixed 0x00)
MinTim
MaxTime(
BatteryChang
e(2bytes
2bytes
e(1byte
Unit:s)
Unit:s)
Unit:0.1v)
Current Change ＜
Change≥
Reportable Change
Report
per Max Interval
Reserved (4Bytes,Fixed 0x00)
Reserved (8Bytes,Fixed 0x00)
Reserved (4Bytes,Fixed 0x00)
5
http://www.netvox.com.cn:8888/page/index
Advertisement
