Table of Content 1. Introduction................................2 2. Appearance................................. 3 3. Main Features................................4 4.Set up Instruction................................ 4 4.1 Power on and Turn on / off..........................4 4.2 Join Into Lora Network............................ 4 4.3 Function Key..............................4 4.4 Data Report..............................5 5.
R718WB2 is a LoRaWAN device compatible with LoRaWAN protocol (ClassA). When the R718WB2 water rope sensor detects a leak, it will send an alarm message to the gateway. When the water rope sensor detects no leaks, it will send a message that shows no leak to the gateway.
The network operation is as following: (1) If R718WB2 had never joined any network or at factory setting mode, turn on the device; it will search an available LoRa network to join. The green indicator will stay on for 5 seconds to show it joins into the network, otherwise, the green indicator will be off.
1. Press and hold both function keys for 5 seconds till the green indicator flashes and then release; LED flashes quickly 20 times. 2. R718WB2 is at off mode by default after restoring to factory setting. Note: The device operation of turning off is the same as the device restore factory settings.
(B) When it is not in the network → R718WB2 will enter sleeping mode and wake up every 15 seconds to search a network to join in the first two minutes. After two minutes, it will wake up every 15 minutes to request to join the network.
9. Important Maintenance Instruction Your device is a product of superior design and craftsmanship and should be used with care. The following suggestions will help you use the warranty service effectively. • Keep the equipment dry. Rain, moisture, and various liquids or moisture may contain minerals that can corrode electronic circuits.