DFI SU256-SCM User Manual page 24

Audio Configuration
This section is used to configure the audio settings.
InsydeH2O Setup Utility
Advanced
HD Audio <Enabled>
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter
HD Audio
Control the detection of the HD audio device.
Disabled
HDA will be unconditionally disabled.
Enabled
HDA will be unconditionally enabled.
Auto
HDA will be enabled if present, disabled otherwise.
Chapter 3 BIOS Setup Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
Control Detection of the
HD-Audio device.
Disabled = HDA will be
unconditionally disabled
Enabled = HDA will be
unconditionally enabled
Auto = HDA will be ena-
bled if present, disabled
otherwise.
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

SATA Configuration
This section is designed to select the SATA controller and the type of hard disk drive which are
installed in your system unit.
Advanced
SATA Controller(s)
SATA Speed
SATA Mode Selection
Serial ATA Port 0
Port 0
Hot Plug
Serial ATA Port 1
Port 1
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
SATA Controller(s)
This field is used to enable or disable Serial ATA devices.
SATA Speed
Select the SATA speed (generation): Auto, Gen1, Gen2, or Gen3.
SATA Mode Selection
The mode selection determines how the SATA controller(s) operates.
AHCI
This option allows the Serial ATA devices to use AHCI (Advanced Host Controller Inter-
face).
RAID
This option allows you to create RAID or Intel Rapid Storage configuration on Serial
ATA devices.
Port 0/1
Enable or disable the serial ATA port.
Hot Plug
Enable or disable hot plug of the SATA port 0 (SATA 3.0).
24 24
InsydeH2O Setup Utility Rev. 5.0
Enable/Disable SATA
<Enabled>
Device.
<Auto>
<AHCI>
Empty
<Enabled>
<Disabled>
Empty
<Enabled>
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi.com www.dfi.com