DFI SU256-SCM User Manual page 22

ACPI Configuration
This section is used to configure the system ACPI parameters.
InsydeH2O Setup Utility
Advanced
ACPI Configuration
Wake on LAN <Disabled>
After G3 <Always>
BGRT Logo <Enabled>
Wake On RTC <Enabled>
Wake up time [00:00:00]
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter
Wake on LAN
This field is used to enable or disable the LAN signal to wake up the system.
After G3
This field is to specify what state to go when power is re-applied after a power failure
(G3 state).
S0 State The system working state.
S5 State System off, except for trickle current to devices such as the power button.
BGRT Logo
This field use to enable or disable to support display logo with ACPI BGRT table.
Note:
BGRT Logo field will appear only when Quiet Boot is enabled. Refer to the Boot
menu later in this chapter for more information.
Chapter 3 BIOS Setup Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
Determines the action tak-
en when the system power
is off and a PCI Power
Management Enable wake
up event occurs.
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Wake on RTC
Wake On Real-time clock (RTC) allows the system to wake up from S4 or S5 states at
the configured time. When enabled, please also set up the Wake Up Time that follows
this field.
Wake up time
When Wake on RTC is enabled, this field will appear. Please configure the time (i.e.
hour, minute, and second) at which the system is specified to wake up.
22 22
www.dfi.com www.dfi.com