Installation; Installing The Remote Unit; Connect The Cat5E Cables; Figure 1- Connect The Extended Components To The Remote Unit - Network Technologies XTENDEX Series Installation And Operation Manual

NTI XTENDEX DVI Video Extender

INSTALLATION

Installing The Remote Unit

1. Position the Remote Unit such that the CAT5 cable and the monitor cables can each reach the Remote Unit without
putting strain on the cables.
2. Connect the monitor cable to the female DVI video connector labeled "Video Out" on the Remote Unit.
Figure 1- Connect the extended video display to the Remote Unit
Connect the CAT5 cables
Make sure the CAT5 cables (two required) have been installed in accordance with the
"Preparation for Installation"
the "Cat5" ports on the Remote Unit. (See Fig. 2.) When properly inserted the
CAT5 cable ends should snap into place.
Note: The two cables must be connected to like ports at each end of
the cables. I.e. It is important that one cable is connected between the
"VIDEO" port at the Remote Unit and the same port at the Local Unit.
The other CAT5 cable must connected between the "DDC/PWR" ports of the
Remote and Local Units. Powering the units with the cables crossed
may damage them.
!
WARNING: Never connect the XTENDEX to an
Ethernet card, Ethernet router, hub or switch or other
Ethernet RJ45 connector of an Ethernet device. Damage to
devices connected to the Ethernet may result.
ST-C5DVI-150 Remote Unit
(Rear View)
DVI-IS-xx-MM
instructions on page 3. Connect the CAT5 cables to
Digital
Multi-Scan
Monitor
Remote User Display
ST-C5DVI-150 Remote Unit
CAT5 Cable to
Local Unit
"DDC/Pwr"
Figure 2- Connect the CAT5 cable to the Remote Unit
4
(Front View)
NTI
R
Network Technologies Inc
XTENDEX
CAT5 Cable to
Local Unit
"Video"