Trouble Shooting - Parkside PDOS 200 B2 Translation Of The Original Instructions

G B MT

Trouble Shooting

Always disconnect the plug from the mains socket before working.
Danger of electric shock.
Problem
Device doesn't start
Grinding tools do
not move although
the engine is run-
ning
Engine is slower
and stops
Grinding disc does
not rotate smoothly,
abnormal noises
can be heard
4 6
Possible Cause
Mains voltage missing
Main circuit breaker is tripped
On/off switch (
defective
Engine faulty
Grinding disc nut (
loose
Workpiece, remaining work-
pieces or remaining grinding
tools block drive
Device is overloaded through
workpiece
Grinding disc nut (
loose
Grinding disc (
Spark protection (1) or work-
piece support (
incorrectly
Error correction
Check the socket, mains cable,
line, mains plug, repairs to be
carried out by qualified electri-
cian if necessary, check main
circuit breaker.
14) may be
Repair by Customer Care
Tighten grinding disc nut (see
10a)
„Changing the grinding disc")
Remove blockages
Reduce pressure on grinding tool
Workpiece unsuitable
10a) Tighten grinding disc nut (see
„Changing the grinding disc")
10) faulty Change grinding disc
Set spark protection or work-
11) set
piece support (see „Assembly")