Trouble Shooting - Parkside PNTS 250 A1 Translation Of The Original Instructions

GB

Trouble Shooting

Always disconnect the plug from the mains socket before working.
Danger of electric shock.
Problem
Device doesn't start
Grinding tools do
not move although
the engine is run-
ning
Engine is slower
and stops
Grinding disc does
not rotate smoothly,
abnormal noises
can be heard
18
Possible Cause
Mains voltage missing
Main circuit breaker is tripped
On/off switch (
defective
Engine faulty
Grinding disc nut (
loose
Workpiece, remaining work-
pieces or remaining grinding
tools block drive
Device is overloaded through
workpiece
Grinding disc nut (
loose
Grinding disc (
Spark protection (
workpiece support (
incorrectly
Error correction
Check the socket, mains cable,
line, mains plug, repairs to be
carried out by qualified electri-
cian if necessary, check main
circuit breaker.
8) may be
Repair by Customer Care
Tighten grinding disc nut (see
22)
"Changing the grinding disc")
Remove blockages
Reduce pressure on grinding tool
Workpiece unsuitable
Tighten grinding disc nut (see
22)
"Changing the grinding disc")
Change grinding disc
1/5) faulty
2) or
Set spark protection or work-
6) set
piece support (see "Assembly")