BMW S 1000RR Rider's Manual page 49

Only dashes are displayed im-
mediately after the ignition is
switched on. The transmission
of the tyre pressure values be-
gins only after the first time the
following minimum speed has
been exceeded:
RDC sensor is not active
min 30 km/h (The RDC sensor
does not send its signal to the
vehicle until the vehicle has
exceeded a minimum speed.)
The tyre pressures
are shown in the TFT
display as temperature
compensated and always
refer to the following tyre air
temperature:
20 °C
If the tyre symbol is ad-
ditionally displayed in yel-
low or red, this is a warning. The
pressure difference is highlighted
with an exclamation point in the
same colour.
If the value in question is
close to the limit of the
permissible tolerance range, the
'General' warning light also lights
up in yellow.
If the tyre pressure re-
gistered by the sensor is
outside the permissible tolerance
range , the 'General' warning light
flashes red.
For further information about the
BMW Motorrad RDC, see the
section entitled "Engineering de-
tails" from page ( 170) on-
wards.
Tyre pressure in limit
range of the permitted
tolerance
with tyre pressure control
OE
(RDC)
General warning light shows
yellow.
is displayed in yellow.
Tyre pressure is not
at setpoint. Check
tyre pressure.
Possible cause:
Measured tyre pressure is close
to the limit of permitted toler-
ance.
Correct tyre pressure.
Before adjusting the tyre pres-
sure, observe the information
on temperature compensation
and pressure adaptation in the
section entitled "Engineering
details":
3
47
z