Connector For Optional Ac - BMW S 1000RR Rider's Manual

Beneath the tail-hump
11
cover
214
1

Connector for optional ac-

z
cessories, rear
Connecting optional
accessories and racing
accessories
Requirement
Remove the side panel, rear seat
or tail-hump cover, as applicable,
to gain access to the plugs.
Removing fairing side panel
with engine spoiler (
with two-up riding package
Removing rear seat (
Remove tail-hump cover
( 79).
Removing tail-hump trim panel
( 198).
Unlock the protective cap or
terminating resistor, as applic-
able, and disconnect it from the
plug.
Connect the optional accessory
or racing accessory, as applic-
able.
NOTICE
Comply with the installation
instructions supplied with the
optional accessory or racing
accessory.
NOTICE
Tightening the cable ties has to
be the last step in the process;
197).
this is in order to ensure that
the wiring harness can be posi-
OE tioned correctly and that there is
no strain on the cable legs with
80).
plugs.
ATTENTION
Dirt and damp penetrating
inside open connectors
Malfunctions
Reinstall the cap or terminating
resistor, as applicable, after re-
moving the plug.
After removing the accessory:
Reinstall the cap or terminating
resistor, as applicable.
Installing side panel (
with two-up riding package
Install the rear seat (
Installing tail-hump cover
( 80).
Installing tail-hump trim panel
( 200).
198).
OE
80).