Table of Contents
Advertisement
Operating a Cable Box or DBS Receiver
Setting the Manufacturer's
Code
You can program the supplied remote
control to operate a cable box or DBS
receiver.
Press CODE SET, DBS/CABLE
(FUNCTION), and the 0-9 buttons to enter
the manufacturer's code number (see the
following chart), then press ENTER.
For example, to operate a Sony DBS receiver:
FUNCTION
CODE SET
DBS/CABLE
8
0
Manufacturer code numbers
(cable box)
Manufacturer
Gemini
222, 223, 224, 225, 226
Hamlin/Regal
Jerrold/G. I.
201, 202, 203, 204, 205,
222, 206, 207, 208, 218
Macom
Magnavox
Oak
Panasonic
Philips
236, 237, 238, 239, 240, 241
Pioneer
Samsung
Scientific Atlanta
Tocom
Zenith
74
Manufacturer code numbers
(DBS receiver)
Manufacturer
Sony
General Electric
RCA/PROSCAN
To operate the cable box or DBS
receiver
1
Press DBS/CABLE (POWER) (green
ENTER
1
labeled button) to turn on/off the cable
box or DBS receiver.
2
Press DBS/CABLE (FUNCTION).
3
For other operations, refer to the
Code
operating instructions that come with the
233
equipment.
If the remote control doesn't work
• Try repeating the set up procedures using
230, 231, 232
the other codes listed for your equipment.
234
227, 228, 229
To operate the projection TV
219, 220, 221
214, 215
Press TV (FUNCTION). Then use the
235
projection TV control buttons to control the
209, 210, 211
projection TV.
216, 217
212, 213
Tips z
• If more than one code number is listed, try entering
them one by one until you come to the correct code for
Code number
your equipment.
801 (preset code for
• If you enter a new code number, the code number you
remote control)
previously entered at that setting is erased.
802
• In some rare cases, you may not be able to operate
802
your equipment with the supplied remote control. In
this case, use the equipment's own remote control
unit.
• Whenever you remove the batteries — to replace
them, for example — if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.
Advertisement
Table of Contents
