Operating A Cable Box; Setting The Manufacturer's Code - Sony KP-XR432K90 Service Manual

Table of Contents

Advertisement

Operating a Cable Box

Setting the Manufacturer's
Code
You can program the supplied remote control
to operate a cable box.
Press CODE SET, CABLE (FUNCTION), and
the 0-9 buttons to enter the manufacturer's
code number (see the following chart), then
press ENTER.
For example, to operate a Pioneer cable box:
FUNCTION
CODE SET
CABLE
2
1
Manufacturer code numbers
(cable box)
Manufacturer
Hamlin/Regal
222, 223, 224, 225, 226
201, 202, 203, 204, 205,
Jerrold/G.I
222, 206, 207, 208, 218
Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith
To operate the cable box
1
Press CABLE (POWER) [Green Button] to
turn on/off the cable box.
2
Press CABLE (FUNCTION).
3
For other operations, refer to the
operating instructions that come with the
equipment.
If the remote control doesn't work
• Try repeating the set up procedures using
the other codes listed for your equipment.
ENTER
4
To operate the projection TV
Press TV (FUNCTION). Then use the
projection TV control buttons to control the
projection TV.
Code
227, 228, 229
219, 220, 221
214, 215
209, 210, 211
216, 217
212, 213
Tips z
• If more than one code number is listed, try entering
them one by one until you come to the correct code
for your equipment.
• If you enter a new code number, the code number
you previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment's own remote control
unit.
• Whenever you remove the batteries — to replace
them, for example — if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.
35

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Kp-xr432n90

Table of Contents