Table of Contents
Advertisement
Installing and Connecting the Projection TV (continued)
Connecting two VCRs for tape
editing
SELECT OUT gives you the ability to use a
second VCR to record a program being
played by the primary VCR or to perform
tape editing and dubbing.
1
Connect the VCR intended for playback
using the connection instructions on page
9 of this manual.
2
Using an AUDIO/VIDEO cable, connect
AUDIO and VIDEO IN on the VCR
intended for recording to AUDIO and
VIDEO OUT of SELECT OUT on the TV's
upper panel.
Notes:
• Do not change the input signal while
editing through SELECT OUT.
• When connecting a single VCR to the
projection TV: if VCR LINE OUT is
connected to VIDEO IN on the TV's
upper panel, do not connect the SELECT
OUT on the TV's upper panel to the VCR
LINE INPUT (see right). Doing so will
cause program interference and other
viewing problems.
• You can select the output signal from
SELECT OUT from the SET UP menu.
(see "SELECT OUT" on page 60)
14
Disconnect all power sources before making any connections.
S-LINK/
CONTROL S
VIDEO
S VIDEO
AUDIO-L
VCR
AUDIO-R
(for playback)
AUDIO R AUDIO L VIDEO
OUT
LINE
OUT
IN
1
(Rear of projectionTV)
VMC-810S/820S
(not supplied)
VIDEO IN
VCR
(Rear of projection TV)
AUX
IN
OUT
VIDEO 1 VIDEO 3 VIDEO 4 (DVD) SELECT
S-LINK/
CONTROL S
OUT
IN
VHF/UHF
Y
VIDEO
VIDEO
P
B
L
L
(MONO)
AUDIO
P
R
R
R
AUDIO
VIDEO
AUDIO-L
AUDIO-R
VMC-810S/820S (not supplied)
SELECT
OUT
Indicates direction
of signal
LINE
IN
OUT
VCR (for recording)
AUDIO R AUDIO L VIDEO
OUT
LINE
IN
IN
2
Advertisement
Table of Contents
