Setting Up The Channel List - Initial Setup - Sony KDS-R60XBR2 Service Manual

Getting Started

Setting Up the Channel List - Initial Setup

26
After you finish connecting the TV, you can run the Initial Setup to create a
list of available analog and digital channels. The Initial Setup screen
appears when you turn on the TV for the first time after hooking it up.
1
Press POWER on the TV front panel to
turn on the TV.
The Initial Setup screen appears.
2
Press V/v to highlight the on-screen
display language, then press
The Date and Time screen appears.
3
Press V/v to change the numbers, and B/b to move between fields.
4
When you finish setting the date and time, highlight "OK" and press
The message "Start auto program now?" appears.
5
Press V/v to highlight "Yes" then press
Auto Program performed through Initial Setup will automatically create a
list of receivable channels from both VHF/UHF antenna and cable TV
channels if both sources are connected.
If you choose to set up the channels at a later time, select the Auto Program
option in the Channel settings to scan available channels (see page 56).
After Auto Program is complete, you will be prompted to set up the TV
Guide On Screen system.
✍
If you select "No" during Initial Setup, the Initial Setup screen will
reappear each time you turn on the TV until you complete Auto
Program.
6
After Auto Program is complete, press
On Screen system setup.
7
When the Welcome screen appears, press
again to begin the setup.
✍
Make sure you finish Auto Program before starting the TV Guide On
Screen system setup. If Auto Program is not completed, you may not be
able to correctly receive program listings.
.
.
to proceed to the TV Guide
.