Assembly - Shop fox W1729 Owner's Manual

Assembly

Before beginning the assembly process, refer to Items.
Needed.for.Setup and gather everything you need.
Ensure all parts have been properly cleaned of any
heavy-duty rust-preventative applied at the factory (if
applicable). Be sure to complete all steps in the assembly
procedure prior to performing the Test.Run.or connecting
the machine to power.
To.install.the.rails.and.fence,.do.these.steps:
1.. Install the table stop hex bolt M8-1.25 x 100 and
M8-1.25 lock nut.
2.. Install the hand wheel handle and the M6-1 x 20 cap
screw for the guide post elevation handwheel.
3.. With the help of an assistant, place the table on the
trunnions as oriented in Figure.13.and install four
M8-1.25 x 16 hex bolts and washers.
4.. Position the large rail at the front of the table so the
mounting holes are aligned with the mounting holes
in the table (see Figure.13).
5.. Install the ⁄ " washers and the
1
4
bolts and tighten.
6.. Position the small rail at the rear of the table so the
mounting holes are aligned with the mounting holes
in the table (see Figure.14).
7.. Install the ⁄ "-20 x
1
4
8.. Slide the fence onto the rails and check the fence
parallelism and adjust as required (refer to Fence.
Parallelism on Page.18).
⁄ "-20 x ⁄
1 3
4 4
⁄ " cap screws and tighten.
5
8
Model W1729 (For Machines Mfd. Since 1/12)
Figure.13..Table and large rail positioning.
" hex
Figure.14..Small rail positioning.
Figure.15..Fence installed.
-16-