Pepperl+Fuchs ICDM-RX/MOD Manual page 51

ICDM-RX/MOD User Manual
Diagnostics Menu
Known Modbus Slave Device List Page - Public Devices (Continued)
Min Rsp Time Displays the minimum response time from the Modbus device.
Max Rsp Time Displays the maximum response time from the Modbus device.
Error Rsp Displays the number of responses with Modbus error indications.
This displays under Configured Remote Modbus Devices the number of times the
network path could not be connected. This could be a result of:
•
No Path
•
•
Displays the number of invalid messages or responses received to any of the
following:
•
Invalid Responses
•
•
Blocked Writes Displays the number of Modbus write messages that were not transmitted for this
device. This only occurs when the Disable Writes (Read Only) serial port option is
selected.
Tx Broadcasts Displays the number of Modbus broadcast messages transmitted to this device.
Known Modbus Slave Device List Page - Private Devices
Displays the device ID associated with this device.
Device ID
Note: If Device ID Offset Mode is enabled, the actual device ID transmitted out the serial
Requests Displays the number of private requests addressed to this Modbus device.
Responses Displays the number of private responses from this Modbus device.
Displays the number of private requests/responses addressed to/from this Modbus
Req Or Resp?
device that could not be identified specifically as either a request or a response.
No Responses Displays the number of requests that this Modbus device did not respond to.
Last Rsp Time Displays the last response time from the Modbus device.
Avg Rsp Time Displays the average response time from the Modbus device.
Min Rsp Time Displays the minimum response time from the Modbus device.
Max Rsp Time Displays the maximum response time from the Modbus device.
Error Rsp Displays the number of responses with Modbus error indications.
Out of Modbus/TCP connections.
Modbus/TCP device not responding.
Incorrect IP address.
Message received after the timeout period. This may require increasing the
Device Response Timeout.
Incorrect device ID in response message.
Incorrect function code in response message.
port displays as (SP=xxx).
51