Serial Interface Logs Page; Known Modbus Slave Device List Page - Pepperl+Fuchs ICDM-RX/MOD Manual

ICDM-RX/MOD User Manual
Diagnostics Menu

6.3. Serial Interface Logs Page

This page displays the serial messages transmitted and received during normal operation. Click Diagnostics |
Communication | Serial Logs to access this page.
The format is as follows:
Pkt(N): ddd:hh:mm:ss.mss Rx/Tx>(data packet)
Where:
ddd – days since last system restart
hh – hours since last system restart
mm – minutes since last system restart
ss – seconds since last system restart
mss – milliseconds since last system restart
(data) – Modbus/RTU or Modbus/ASCII message data.
• Private messages between the master and slaves on the Master/Slaves ports are indicated with "(Private)".
• All other messages are those routed through the Modbus gateway to the Modbus network or Shared
Memory.

6.4. Known Modbus Slave Device List Page

The Known Modbus Slave Device List page provides device specific status and statistics for each device
connected locally to one or more of the serial ports or remotely through a remote Modbus/TCP device
configuration.
Access the Known Modbus Slave Device List page by clicking Diagnostics | Modbus Diagnostics | Modbus
Devices.
The following table provides detailed information about this page.
Known Modbus Slave Device List Page - Public Devices
Displays the device ID associated with this device.
Device ID
Note: If Device ID Offset Mode is enabled, the actual device ID transmitted out the
Displays the status of device:
•
Active?
•
Displays the IP address associated with the local device under Configured Remote
IP Address
Modbus Devices.
Displays the TCP/IP port associated with the remote device under Configured Remote
IP Port
Modbus Devices.
Tx Req Displays the number of Modbus messages transmitted to this device.
Rx Rsp Displays the number of Modbus responses received from this device.
Timeouts Displays the number of response timeouts associated with this device.
Last Rsp Time Displays the last response time from the Modbus device.
Avg Rsp Time Displays the average response time from the Modbus device.
50
serial port displays as (SP=xxx).
Yes means that the last request received a valid response and did not time out.
No means that the last request timed out or the device has not yet received a
message.