Table of Contents
Advertisement
ICDM-RX/MOD User Manual
Configuration Overview
2. Configuration Overview
This section provides an overview of how to configure the ICDM-RX/MOD and discusses the Home page.
2.1. Prerequisites
Before you can configure Modbus Router on the ICDM-RX/MOD, you must have previously performed the
following steps:
•
Installed the hardware.
•
Installed PortVision DX.
•
Configured the ICDM-RX/MOD IP address using PortVision DX.
Note: If necessary, refer to the ICDM-RX/MOD Hardware Installation and Configuration Guide for the above
procedures.
2.2. Configuration Overview
The following overview shows how to access the ICDM-RX/MOD Router Configuration embedded web pages.
If you have not configured the network information into the ICDM-RX/MOD during initial setup, you must
configure the network information before configuring serial/socket port characteristics. See the PortVision DX
help system for help configuring the network settings.
1. From PortVision DX, highlight the ICDM-RX/MOD that you want to configure and select Webpage.
Note: Optionally, enter the IP address of the device in the Address box of your web browser.
2. Select the appropriate procedure for your environment.
Serial Modbus Master, Slave, or Master/Slaves
a. Click the Serial tab, which defaults to the Serial Port Overview page.
b. Click the port that you want to configure.
c. Change and save the serial port configuration properties as required for your installation.
Ethernet TCP/IP Modbus Master
a. Click the Modbus tab, which displays the Modbus over TCP Overview (not Modbus/TCP) page.
b. Click the socket that you want to configure.
c. Change and save the Ethernet TCP/IP configuration properties as required for the interface.
Modbus/TCP Device
a. Click the Modbus tab, which displays the Modbus over TCP Overview (not Modbus/TCP) page.
b. Click the Modbus/TCP Configuration sub-menu.
c. Change and save the Modbus/TCP configuration properties as required for the device.
Remote Modbus/TCP Device
a. Click the Modbus tab, which displays the Modbus over TCP Overview (not Modbus/TCP) page.
b. Click the Remote Modbus/TCP Device Configuration sub-menu.
33
Advertisement
Table of Contents
Troubleshooting
