Xser Interfaces And Xvid Interfaces - Bosch Rexroth IndraControl VDP 15.3 Operating Instructions Manual

Bosch Rexroth AG
Interfaces
Operation of the USB ports on the operating display
The USB speed at the operating display depends on the cable length of the
XSER connection and of the DIP switch setting, see
pending on the XSER cable length" on page
Cable length of the
XSER connection
Up to 5 meters
Up to 5 meters
From 5 to 30 meters
Longer than 30 me-
ters
Tab. 9-3: USB speeds depending on the XSER cable length
Interference-free USB2.0 connection is possible up to a cable length
of 5 meters only.
Connect only USB devices that meet the USB2.0 specification.
The cables of the connected USB devices have to comply with the
USB2.0 specifications.
If the total current of all USB ports exceeds 1 A and switches the
power supply unit of the operating display off.

9.6 XSER Interfaces and XVID Interfaces

CDI interface
The CDI interface is assigned to the two RJ45 female connectors XSER and
XVID. The connection between the control cabinet PC and the operating display
is established on these female connectors via two ready-made cables available
as accessory, see chapter 5 "Spare Parts, Accessories and Wear Parts" on page
6.
The CDI interface includes the data interface (XSER) as well as the screen inter-
face (XVID).
XVID and XSER Markings
The CDI interfaces are color-coded on the device:
14/37
DIP switch 2 USB speed
OFF 12 Mb/s
OFF 480 Mb/s
(USB2.0)
OFF 12 Mb/s
ON 12 Mb/s
VDP 15.3, 18.3, 21.3 Multitouch
tab. 9-3 "USB speeds de-
14:
Note
-
An additional USB cable between con-
trol cabinet PC and XUSBIN is required
Make sure that the connected device
does not contain a USB hub
Only a mouse and keyboards can be
connected. Make sure that the connec-
ted device does not contain a USB hub
DOK-SUPPL*-VDPXX.3MTBU-IT02-EN-P