Symbols Used; Intended Use - Bosch Rexroth IndraControl VDP 15.3 Operating Instructions Manual

VDP 15.3, 18.3, 21.3 Multitouch

3.3 Symbols Used

Notes are displayed as follows:
This is a note.
Tips are displayed as follows:
This is a tip.

4 Intended Use

The Bosch Rexroth operator terminals are passive operation and visualization
terminals. They form a PC-based operator terminal when used with a Bosch
Rexroth control cabinet PC.
NOTICE
The operator displays may be used only as intended and with the accessories,
mounting parts and other components specified in this documentation. Compo-
nents that are not expressly mentioned must neither be attached nor connec-
ted. The same is valid for cables and lines.
Operation must only be carried out with the hardware component configura-
tions and combinations that are expressly specified and with the software and
firmware indicated and specified in the respective documentation and function-
al descriptions.
Typical areas of application of the operator displays are:
Handling systems and assembly systems
●
Packaging and food processing machines
●
Printing machines and paper converting machines
●
Machine tools
●
Wood processing machines
●
The operator displays may only be operated under the mounting and installation
conditions, the position, and the ambient conditions (temperature, degree of
protection, humidity, EMC etc.) specified in this documentation.
DOK-SUPPL*-VDPXX.3MTBU-IT02-EN-P
Danger of destruction of the device if not ex-
pressly stated accessories, mounting parts and
other components, cables, lines, software and
firmware are used.
Bosch Rexroth AG
Intended Use
5/37