Choosing The Default Export Folder - Keysight Technologies M9703A Startup Manual

Choosing the Default Export Folder

A – The open file dialog allows the user to pick a calibration input table following the
format as shown in the example below. The file starts with a specifier for phase angle
units ("Degrees" or "Radians") and then follows with tables of magnitude and phase
correction values per M9703A digitizer module. The first line of each M9703A table is
the VISA PXI address of the specific M9703A that the cal constants are provided for. If
there is more than one M9703A, then the next PXI address is given on the very next
line followed again by the list of channels with associated magnitude, phase
correction.
Degrees
Keysight Y1299A-003 MAC Reference Solution Startup Guide
PXI17::0::0::INSTR
Channel2,1,1.74
MAC Demo Software
Setup tab
31