Washing Procedure - Royal Enfield Himalayan BS IV 2018 Owner's Manual

WASHING PROCEDURE

PRECAUTIONS
 Wash motorcycle when the engine is cold.
 Cover the silencer, tail pipe, horn and control switches with suitable plastic bags and tie it firmly to prevent water
entry.
 Remove ignition key and seal key hole using adhesive tape.
 Brush engine area with a solvent to remove dirt or grease.
 Use low pressure jet of water to clean.
 DO NOT spray water directly on the steering stem area as it will damage the bearings and course the handle bar
movement to become sticky.
 Never spray water with great force on head lamp, speedometer, flasher lights, front and rear wheel hubs, electrical
connections and wires, control cables, spark plug, battery, side mirrors, steering stem, etc.
 Do not apply any corrosive solvent on painted surfaces or rubber parts.
 Use luke warm water and mild detergent on the painted components to remove dirt, etc.
103