Royal Enfield Himalayan BS IV 2018 Owner's Manual page 105

WASHING PROCEDURE
Rinse motorcycle thoroughly with plain water to remove the detergent.

If possible, use compressed air and blow off water particles from the hard to reach areas of the motorcycle, electrical

connections etc.
No direct jet at the edges of decal, electrical parts, coupler joints, silencer tail pipe, radiator lubrication points like

steering cone kit, brake pedal, wheel bearings, chain, brake cam & swing arm bushes to be washed in spray mode only
(not in jet mode).
AFTER WASHING
Ensure, the motorcycle is thoroughly dry by wiping with a clean soft absorbent cloth or chamois leather.

Remove all plastic bags and adhesive tapes.

Lubricate control cables, pivot and rear chain with lube oil.

Polish the painted (except Stone Black Colour / Matt paint finish) and plated surfaces using polishing wax.

Start engine and allow to run at idling speed for a few minutes to warm up engine.

Drive the motorcycle slowly, applying both brakes intermittently to dry up the water in the brake shoes.

104