AUTEC C26 PRO Series Manual

1 CONVENTIONS
2 CONFORMITY
The C26 PRO series PRO-M radio remote control is in conformity with the
R&TTE 99/05/EC Directive and its essential requirements.
The radio remote control is also in conformity with the norms given in the EC confor-
mity declaration that is included in this manual.
In Technical Data (see chapter 14) there are the characteristics of safety functions
according with EN 954-1.
As required by the Machines Directive and relative harmonised standards, all machi-
nes must undergo a risk analysis; therefore it is necessary to evaluate, within the li-
mits of this analysis, if the machine can be radio remote controlled.
The machine producer and/or the person who decides upon radio remote control use
and installation is responsible for this analysis.
Autec cannot be held responsible if the risk analysis is not carried out cor-
rectly and if the radio remote control is installed on applications that are dif-
ferent from those permitted:
To guarantee correct radio remote control operation, all current regulations regarding
safety at work and accident prevention should be respected. All current user country
national laws regarding the use of both the machine and the radio remote control
MUST ALWAYS be respected.
Autec cannot be held responsible if the radio remote control is used in un-
lawful working conditions.
LIPROMU2-01
Any pieces of text written in bold should be read very carefully.
This symbol highlights extremely important indications and information whi-
ch, if not observed, can create seriously dangerous situations for people,
equipment or property.
This symbol highlights all important indications and information that deal
with operation.
It should be remembered that in some countries rules which control
the use and/or possession of a radio remote control must be res-
pected (see the enclosed "Limitations & Authorisations").
Some national limitations may be present for the use of frequencies
which have not yet been harmonised in European countries. Before
using the radio remote control, verify that it works in a frequency
band which is allowed by national radiocommunication laws.
PERMITTED APPLICATIONS:
Hoisting and moving machines installed exclusively on vehicles that
use a battery as electrical power supply source (for example:
hydraulic cranes, concrete pumps . . .)
FORBIDDEN APPLICATIONS
- machines installed in areas where equipment with explosion-proof
characteristics are being used
- AC supplied machines
- machines using a DC supply that does not come from a battery
- machines where risk analysis regarding verification of radio remo-
te control conformity to the application is not possible or has given
a negative or uncertain result.
- 17 -
English