Installation - Zennio MAXinBOX 66 Manual

1.2 INSTALLATION

MAXinBOX 66 connects to the KNX bus through the on-board KNX connector.
Once the device is provided with power from the KNX bus, both the individual address
and the associated application program may be downloaded.
This device does not need any additional external power since it is entirely powered
through the KNX bus.
3
4
5
The main elements of the device are described next.
Test/Prog. Pushbutton (8): a short press on this button sets the device into
the programming mode, making the associated LED (5) light in red.
Note: if this button is held while plugging the device into the KNX bus, the
device will enter into safe mode. In such case, the LED will blink in red every
0.5 seconds.
Outputs (2 and 6): output ports for the insertion of the stripped cables of the
systems being controlled by the actuator (see section 2.3). Please secure the
connection by means of the on-board screws.
Inputs (1): input ports for the insertion of the stripped cables of external
elements such as switches / motion detectors / temperature probes, etc. One
http://www.zennio.com
1
2
8
7
6
Figure 1. MAXinBOX 66. Elements
1. Analogue/Digital Inputs.
2. Upper Outputs.
3. Output LED Indicator.
4. Manual Control Pushbutton.
5. Test/Prog. LED.
6. Lower Outputs.
7. KNX Bus Connector.
8. Test/Prog. Pushbutton.
Technical Support: http://support.zennio.com
MAXinBOX 66
5