Selectable Power On Led - Kenwood ProTalk NX-P500 User Manual

SELECTABLE POWER ON LED

Setting the color of the LED that lights up when the power is on, groups can be
color coded when grouping is necessary. Once you have decided on the color of
group, you can judgment which group immediately after turning on the power.
You can set the colors of the LED that light up at power on from 7 types.
It will light for about 2 seconds.
To set the power on color type of LED:
1
Enter the Setting mode {p.30}.
2
Press the button programmed as [Channel Up] or [Channel
Down] to select "
3
Press the button programmed as [Channel Menu] then press the button
programmed as [Channel Up] or [Channel Down] to select your desired
value.
Yellow
Purple
Light Blue
Green
White
4
Press the button programmed as [Channel Menu] to confirm the selection,
then press the PTT switch or the Side button to exit to the operation mode.
".
OFF Even if the power is turned on, the LED does not light up.
When the power is on, the LED will light yellow for about 2
seconds.
When the power is on, the LED will light purple for about 2
seconds.
When the power is on, the LED will light blue for about 2
Blue
seconds.
When the power is on, the LED will light light blue for about 2
seconds..
When the power is on, the LED will light red for about 2
Red
seconds.
When the power is on, the LED will light green for about 2
seconds.
When the power is on, the LED will light white for about 2
seconds.
47