Kenwood ProTalk NX-P500 User Manual page 14

n Home Channel Select
Press this button to set the current channel as the Home Channel.
n ID List
Enters Selcall Mode. In Selcall Mode, a call can be initiated by selecting an ID
registered in the ID List.
n Individual Reply
FleetSync:
After a Group Call or a Broadcast Call (All Call) is received by a Selcall, an
Individual Call can be initiated to the transmitting transceiver by pressing the PTT
switch after pressing the Individual Reply button while the ID of the transmitting
transceiver is appeared.
NXDN:
After a Group Call or an All Group Call is received, an Individual Call can be
initiated to the transmitting transceiver by pressing the PTT switch after pressing
the Individual Reply button while the ID of the transmitting transceiver is
appeared.
n Maintenance
Enter Maintenance Display Mode and the signal strength numerically.
n Monitor
Stops monitoring QT tone or DQT code and opens the squelch on receipt of a
carrier (Analog mode only), or releases the matching state of RAN code and
Optional Signaling and unmutes audio upon detection of the NXDN frame (NXDN
mode only).
n Monitor Momentary
While the Monitor Momentary button is pressed, monitoring the QT tone or DQT
code pauses and the squelch opens on receipt of a carrier (Analog mode only), or
the matching state of RAN code and Optional Signaling is released and audio is
unmuted upon detection of the NXDN frame (NXDN mode only).
n Scan
Press this button to start scanning the transceiver channels.
n Scan Delete/Add
Adds or removes the selected Channel to or from the scan sequence.
n Second PTT
Apart from the channel you normally select, you can set up another channel as
the main channel with a dedicated PTT switch.
n Speaker Attenuation
14