Table of Contents
Advertisement
Name
On-board screw terminal for GND (VSSE), VDDE2 (to VDDE), VDDA, and TS1 connections. (Note: The TS1 pin is not
KL1
applicable to the ZSSC4175D-01.)
KL2
On-board screw terminal for TS2, VSSA, TOP, and BR2P. (Note: The BR2P pin is not applicable to the ZSSC4151 and the
TS1 pin to the ZSSC4175D-01.)
KL3
On-board screw terminal for BR2N, BR1P, BR1N, and BOT. (Note: The BR2N pin is not applicable to the ZSSC4151.)
K1, K9
Powers (enables) the headers for connecting external Sensor 1 and Sensor 2 modules (K2 and K5 respectively) via KS5V.
K2, K5
Headers for connections for external Sensor 1 or Sensor 2 modules. Sensor 2 (K5) is intended only for SENT input one-way
transmission (Sensor 2 is not applicable to the ZSSC4151). The ZSSC4151 requires the OWI interface to use Sensor 1 (K2).
K4, K6
Header strips for access to all ZSSC41xx signals; K6 can be used to connect directly to the DUT for in-circuit programming.
K7
2-pin header for connecting the KS5V supply to the VDDE pin (leave jumper open when the external power supply VDDE2 is
connected); provides test points for simple supply current measurements.
K8
Connects the external SSC-SRB temperature sensor to the DUT's TS1 or TS2 inputs. (Note: The TS1 and TS2 pins are not
applicable to the ZSSC4175D-01.)
S1
Switch that is used for interface selection between OWI and SENT. (Set to OWI for the ZSSC4151.)
24-QFN
Socket for inserting the 24-QFN 4mm
K11
Mass Calibration Board (MCB) DUT connector.
© 2019 Integrated Device Technology, Inc.
Description
4mm ZSSC41xx DUT.
6
ZSSC41xx SSC Evaluation Board User Guide
May 13, 2019
Advertisement
Table of Contents
