Chapter 3. Installation; Preparation - IBM 5147-084 Installation And User Manual

Chapter 3. Installation

Preparation

Before you start, familiarize yourself with the required safety precautions.
Important: Before you attempt to install the system, read Safety and environmental notices and
Chapter 1, "Appliance safety precautions," on page 1.
Important: The enclosure must be mounted in a rack before use.
Important: Only service personnel should install the system.
ESD precautions
Fit and check a suitable anti-static wrist or ankle strap and observe all conventional ESD precautions
when handling plug-in modules and components. Avoid contact with backplane components and module
connectors.
Site requirements
Before you begin, make sure the site where you intend to set up and use your storage system has the
following utilities and equipments:
v Standard power from an independent source or a rack power distribution unit.
v ESS IO Server nodes with correct software.
Before setting up your enclosure, ensure ESS I/O server nodes have the SAS HBA installed in the correct
slot. Ensure that you have the following equipment:
v Mini SAS to mini SAS HD cable
v Power cord
v Rack kit
The accessory box contains the power cords and other ordered accessories.
Unpacking the system
CAUTION:
A fully configured enclosure weighs up to 135kg (298lb). An unpopulated enclosure weighs 46kg
(101lb). To lift the enclosure out of the shipping box, use appropriate lifting methods. The packaging
includes lifting straps wrapped and buckled around the enclosure. Make sure the lifting strap buckle
is properly closed, and lift with the loops attached to the lifting straps.
1. Position the shipping case within 2m (6 feet) of the site where you intend to use your storage system.
2. Inspect the packaging for crushes, cuts, water damage or any other evidence of mishandling during
transit. If there is any damage, photograph the packaging for future reference before opening.
3. Remove the packaging, as shown in the following figure.
19
© Copyright IBM Corp. 2017