IBM 5147-084 Installation And User Manual page 64

4. Pull the module out of the enclosure (2).
Important: The SBB I/O module bay must not be empty for more than two minutes while the
enclosure is powered.
Inserting an SBB I/O module
1. Rotate the SBB I/O module so that the release latch is at the bottom.
2. Open the release latch and rotate it to its most open position, as shown in the previous figure.
3. Slide the I/O module into its slot until it will go no farther and the handle has started to close.
4. Close the latch until it clicks home. This levers the module home into its connector on the midplane.
The enclosure automatically detects the new unit.
5. Connect the cables to the new module. If necessary, refer to the note you made before you removed
the cables from the defective I/O module.
48
Installation and User Guide - Model 084