Acoustics; Ac Power Cords; Potential For Radio Frequency Interference; Power Cord Specifications - IBM 5147-084 Installation And User Manual

Packaging
The IBM ESS expansion Model 084 enclosure complies with the Packaging (Essential Requirements)
Regulations 2003.
The design minimizes the amount of packaging used, and the packaging is designed for reuse, recovery
or recycling, to reduce the environmental impact of packaging waste.

Acoustics

Model 084 produces an operating sound power of < L
73°F (23°C).

AC power cords

If supplying your own power cord, you must meet a number of specifications.
Table 16. Power cord specifications
Country Cord type
USA SJT or SVT, 12 AWG
minimum, 3
conductor
Europe & Others Harmonized,
H05-VVF-3G2.5
Important: The plug and the complete power cord assembly must meet the standards appropriate to the
country, and must have safety approvals acceptable in that country.

Potential for radio frequency interference

USA Federal Communications Commission (FCC)
Note: This equipment has been tested and found to comply with the limits for a class A digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission
limits. The supplier is not responsible for any radio or television interference caused by using other than
recommended cables and connectors or by unauthorized changes or modifications to this equipment.
Unauthorized changes or modifications could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
56
Installation and User Guide - Model 084
8.2 Bels (re 1pW) at an ambient temperature of
WAd
Plug (AC source) Socket (PSU socket)
IEC 320 C20, 250V, IEC 320 C19, 250V,
20A or a suitable plug 20A
rated 250V, 20A
IEC 320 C20, 250V, IEC 320 C19, 250V,
16A or a suitable plug 16A
rated 250V, 16A
Comments
Must be UL certified.