Anti-Tamper Locks (Shown Disengaged); Opening The Bottom Drawer - IBM 5147-084 Installation And User Manual

Opening a drawer
1. Make sure the anti-tamper locks are not engaged. The red arrows on the locks will point inwards if
the locks are disengaged (see the following figure). Unlock them if necessary by rotating them
counterclockwise using a screwdriver with a Torx T20 bit.
Figure 27. Anti-tamper locks (shown disengaged)
2. Push the drawer latches inward and hold them (see the following figure).
Figure 28. Opening the bottom drawer
3. Pull the drawer all the way out until it locks open.
Important: The drawer must not be left open for more than two minutes while the enclosure is
powered.
38
Installation and User Guide - Model 084