Table of Contents
Advertisement
10
Press OK to accept the change.
The display changes to a flashing display of the current time (minutes).
11
Use Up/Down to change the minutes.
Between 00 and 59.
12
Press OK.
The display returns to the menu selection screen.
13
Press Cancel.
Returns controller to normal operation.
Power Source
This menu programs Touchpoint 1 for the type of available power source(s).
The controller can be set to any of three different power supply modes.
1
Access the menu system and select the
Press Up or Down. The icon flashes.
2
Press OK.
The display shows one of the following current selected power modes:
•
dC-1 — AC only power supply
•
dC-2 — AC and DC power supplies
•
dC-3 — DC only power supply
3
Use Up/Down to select the required power configuration.
Note
If the system is powered by an AC supply, only dC-1 or dC-2 should be selected.
If the system is powered by a DC supply, only dC-2 or dC-3 should be selected.
4
Press OK.
The display returns to the menu selection screen.
5
Press Cancel.
Returns controller to normal operation.
Default Configuration
Touchpoint 1 is supplied from the factory with a standard default configuration.
The configuration is based on settings typically used in gas detection systems.
The two versions of Touchpoint 1 are factory configured as follows.
TP1MAN Issue 3 Apr 06 (MAN0630)
menu option.
User Settings
45
Advertisement
Table of Contents
