Download  Print this page

Honeywell 10260S series Replacement Instructions

Auto-manual switch.
Hide thumbs
   

Advertisement

Auto-Manual Switch Replacement Instruction
Document Number
Form: 62-86-33-26
Effective: 06/01
Supersedes: none
Overview
These instructions apply to the following kit: 51500581-501 Auto-Manual Switch Kit and its application to
the 10260S Series Actuators.
Summary
The AUTO-MANUAL switch of the 10260S Actuator is used as a manual override to drive the actuator
motor to position during set up. The Auto-Manual switch kit contains the components needed to add the
switch function to your actuator, or replace a defective switch. Follow the procedure in Table 1 to install the
Auto-Manual switch.
Tools Needed
To perform the replacement procedure, you will need the following tools:
• Medium Flat-blade screwdriver
• Medium Phillips screwdriver
• Small jeweler's screwdriver set
• Small adjustable wrench
• Needle-nosed pliers
• Heat gun
Procedure
WARNING
Disconnect power before accessing components inside the actuator.
ATTENTION
When working with Printed Wiring Assemblies (PWAs) always protect against electrostatic discharge by
wearing a grounded wrist strap.
62-86-33-26
10260S Series Actuators
Page 1 of 5

Advertisement

   Related Manuals for Honeywell 10260S series

   Summary of Contents for Honeywell 10260S series

  • Page 1 Supersedes: none Overview These instructions apply to the following kit: 51500581-501 Auto-Manual Switch Kit and its application to the 10260S Series Actuators. Summary The AUTO-MANUAL switch of the 10260S Actuator is used as a manual override to drive the actuator motor to position during set up.
  • Page 2 Auto-Manual Switch Instruction, continued AUTO-MANUAL Switch Terminal Panel Figure 1 AUTO-MANUAL Switch Location Table 1 AUTO-MANUAL Switch Installation Procedure Step Action Remove AC power to the actuator. Remove four screws and the terminal panel cover from the actuator. See Figure 1 Remove two screws and pull out the terminal panel from the actuator case.
  • Page 3 Auto-Manual Switch Instruction, continued Step Action If replacing the switch, disconnect switch wires and remove switch: • Carefully disconnect auto-manual switch wires at the rear of the terminal panel from the following lugs: TB1-1, TB1-8, TB1-9, TB2-12, TB2-13, TB2-10, TB2-11. (Looking at the rear of the terminal panel - TB1 is the top terminal board.
  • Page 4 Auto-Manual Switch Instruction, continued Step Action Connect switch wires: • If adding (not replacing) the switch, remove blue and orange wires from TB1-8 and TB1-9. Connect blue wire to TB2-13 and orange wire to TB2-12. • If adding or replacing the switch, one at a time connect auto-manual switch wires as follows: AUTO-MANUAL TO: Terminal Panel Lugs Switch Wires...
  • Page 5 Contact your local sales office for warranty information. If warranted goods are returned to Honeywell during the period of coverage, Honeywell will repair or replace without charge those items it finds defective. The foregoing is Buyer's sole remedy and is in lieu of all other warranties, expressed or implied, including those of merchantability and fitness for a particular purpose.

Comments to this Manuals

Symbols: 0
Latest comments: