Super - H3C S3610 Series Command Manual

Command Manual – System Maintaining and Debugging
H3C S3610&S5510 Series Ethernet Switches
Examples
# Return to user view from Ethernet port view.
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] return
<Sysname>

1.1.18 super

Syntax
super [ level ]
View
User view
Parameters
level: User level, in the range 0 to 3.
Description
Use the super command to switch from the current user level to a specified user level.
There are four levels of commands:
Visit: involves commands for network diagnosis (such as ping and tracert),
commands for accessing an external device (such as Telnet client, SSH client,
RLOGIN). Saving the configuration file is not allowed at this level.
Monitor: includes the display and debugging commands for system maintenance,
and service fault diagnosis. Saving the configuration file is not allowed at this level.
System: provides service configuration commands, including routing and
commands at each level of the network for providing services.
Manage: influences the basic operation of the system and the system support
modules for service support. Commands at this level involve file system, FTP,
TFTP, Xmodem download and configuration file switch, power control, standby
board control, user management, level setting, as well as parameter setting within
a system (the last case involves those non-protocol or non RFC provisioned
commands).
Login users are also classified into four levels that correspond to the four command
levels. After users at different levels log in, they can only use commands at their own, or
lower, levels.
Note that:
Users can switch to a lower user level unconditionally. To log in through AUX, or VTY
user interface and switch to a higher user level, however, they need to enter the
password (The password can be set with the super password command.). If the
Chapter 1 Basic Configuration Commands
1-19