Hotkey - H3C S3610 Series Command Manual

Command Manual – System Maintaining and Debugging
H3C S3610&S5510 Series Ethernet Switches
* Copyright (c) 2004-2007 Hangzhou H3C Tech. Co., Ltd. All rights reserved.*
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
**************************************************************************
Welcome to legal(header legal)
Press Y or ENTER to continue, N to exit.
Welcome to motd(header motd)
Welcome to login(header login)
<Sysname>

1.1.15 hotkey

Syntax
hotkey { CTRL_G | CTRL_L | CTRL_O | CTRL_T | CTRL_U } command
undo hotkey { CTRL_G | CTRL_L | CTRL_O | CTRL_T | CTRL_U }
View
System view
Parameters
CTRL_G: Assigns the hot key <Ctrl+G> to a command.
CTRL_L: Assigns the hot key <Ctrl+L> to a command.
CTRL_O: Assigns the hot key <Ctrl+O> to a command.
CTRL_T: Assigns the hot key <Ctrl+T> to a command.
CTRL_U: Assigns the hot key <Ctrl+U> to a command.
command: The command line associated with the hot key.
Description
Use the hotkey command to assign a hot key to a command line.
Use the undo hotkey command to restore the default.
By default, the system specifies corresponding commands for <Ctrl+G>, <Ctrl+L> and
<Ctrl+O>, while the others are null.
<Ctrl+G> corresponds to display current-configuration
<Ctrl+L> corresponds to display ip routing-table
<Ctrl+O> corresponds to undo debugging all
You can customize this scheme as needed however.
Chapter 1 Basic Configuration Commands
1-16
*
*