Payload Mounting; Side Bracket Attachment - FLIR PTU-5 User Manual

4.8 - Payload Mounting

The PTU payload bracket system can be configured in a number of ways to support a variety of payloads
including cameras, lasers, antennas, and other equipment. Figure 3 shows all bracket configurations
available for the PTU-5.
WARNING: FAILURE TO FOLLOW ALL PAYLOAD MOUNTING INSTRUCTIONS COULD
RESULT IN A STRUCTURAL FAILURE THAT MAY RESULT IN DEATH, PERSONAL INJURY,
AND/OR DAMAGE TO THE UNIT.
The following guidelines apply to all payload mounts:
• The maximum payload mounting screw diameter is 1/4" when using the center hole on each bracket
(slots accommodate smaller screws). Also, payload mounting screws must not extend more than
1/8" below the top mounting bracket, to avoid gouging the PTU housing.
• Always use washers, lock washers, etc. as appropriate.
• If the PTU is being mounted in an outdoor location, use corrosion-resistant hardware (such as
stainless steel).
• Apply thread locking compound to all screws, such as Loctite® 242, which is suitable for applications
that are field serviceable since it is easily removable with common hand tools and works with both
stainless and plated metals. Consider other compounds for high-shock/vibration applications where
field service is not a concern.
The PTU-5 allows the following bracket mounting options:

4.8.1 - Side Bracket Attachment

To attach side mounting brackets:
1. Verify that the PTU has been powered on and allowed to reset, which places the mounting hub in its
"home" position.
2. Power off the PTU.
20
Copyright 2017, FLIR Commercial Systems, Inc.
PTU-5 User Manual
Figure 4-2: Bracketing Options