3 Battery; 4 Turn On The Ups; 5 Turn Off The Ups; Battery Recharge - ABB PowerValue 11T G2 Series User Manual

14 P O W E R VA L U E 1 1T G 2 1 - 3 K VA B/ S
—

3 3 Battery

3 3 1
Fully charge the UPS system's external batteries
by leaving the UPS system connected to the
mains power for approximately 1-2 hours.
The UPS system can operate directly without
recharging, but the backup time may be shorter
than the nominal value specified.
—

3 4 Turn on the UPS

3 4 1
Press and hold the ON button for more than 1
second to turn on the UPS. The UPS will be in Line
mode; and the LCD screen will indicate the state
of the UPS.
3 4 2
Even though mains power is not connected to the
UPS, the UPS still can be turned on by just simply
pressing the ON button continuously for more than
1 second when the external batteries connected.
The UPS will turn on in Battery mode, and the LCD
screen will indicate the state of the UPS.
—

3 5 Turn off the UPS

3 5 1
Press the OFF button continuously for more than
1 second to turn off the UPS. The UPS will enter no
output or bypass mode. In some circumstances,
the UPS might have output power if bypass mode
is enabled. Disconnect the mains power to turn
off the output.

Battery recharge

With mains power connecting

Without mains power connecting

In Line Mode

3 3 2

Test function

Test function means checking the UPS system's
battery performance by pressing the On-Switch for
more than 1 second while the UPS is operating in
Line mode. The UPS will detect whether the battery
is connected, or if the battery is weak. The UPS can
implement this test automatically and periodically.
The battery test period is configurable.
BY DEFAULT, THE OUTPUT IS DISABLED
WHEN THE UPS IS IN BYPASS MODE; THIS
CAN BE MANAGED IN THE USER SETTINGS
(SEE 5.1).
NOTE
3 5 2

In Battery Mode

Press the OFF button continuously for more than
1 second to turn off the UPS. The UPS will enter no
output or standby mode. After 10 seconds, the UPS
will be shut down completely.