6 Alarm Mute Function; Battery Mode; Bypass Mode; Cvcf Mode - ABB PowerValue 11T G2 Series User Manual

3 G E T T I N G S TA R T E D
—

3 6 Alarm mute function

3 6 1
To mute the audio alarm in battery mode, press
the ON button continuously for 1 second. The
audio alarm is active again when the battery
reaches low status as a reminder that the UPS
output power will shut down soon.
3 6 2
To mute the audio alarm in bypass mode, press the
OFF button continuously for more than 1 second.
This does not affect the warning and fault alarm.
3 6 3
The UPS can be used in CVCF mode without
batteries. This will cause the Open Battery alarm
to sound. To mute this alarm in CVCF mode, use
the software.
3 6 4
To mute the audio alarm in any other mode, press
the ON button for less than half (0.5) a second.
You can enable the audio alarm again by pressing
the ON button for less than half (0.5) a second
again. If the new warning or fault alarm appears,
the buzzer will beep again.

Battery mode

Bypass mode

CVCF mode

Other modes

3 6 5

Alarm indicators

The audio alarm has a series of beeps based
on the active mode or a particular warning.
See Table 8 below for the number/duration
of beeps for warning/mode.
—

Table 8: Alarm function list

No Status
1 Battery mode
Battery mode with
2
battery low
3
Bypass mode
4 Overload
Warning active
5 (See Warning &
Fault Code Table)
6 Fault active
7 Button function active
15
Alarm
Beeps once every
4 seconds.
Beeps once every second.
Beeps once every
2 minutes.
Beeps twice every
second.
Beeps once every second.
Beeps continuously.
Beeps once.