Installing The Software; Windows 95; Windows 3.1 - Atmel megaAVR Getting Started

Hide thumbs

Table of Contents

5.1

Windows 95

5.2

Windows 3.1

megaAVR™ Starter Kit Manual

To install the software, insert the supplied disk or CD-ROM into your computer and per-

form the following steps:

1. Click on the "Start" button.

2. Select "Settings".

3. Select "Control Panel".

4. Choose "Add/Remove Programs".

5. Click the "Install" button.

6. Follow On-Screen prompts.

The software will then be installed onto your computer and an Icon will be added to your

start menu.

Choose "RUN" from Program Manager, and enter A:\SETUP.EXE as the filename.

Press the "OK" button and the software installation program will begin.

The software will then be installed onto your computer and an Icon and Program Group

will be added to Program Manager.

Note: On some PCs, especially laptops, programming problems may occur if the

BIOS Parallel Port settings are set to EPP Version 1.7. If programming prob-

lems do happen, ensure that the Parallel Port settings in your BIOS are set to

EPP V1.9 not V1.7. This applies to both Windows 95 and Windows 3.1 based

PCs.

In the unlikely event that you have any problems installing the software or suspect that

you have faulty media, please contact the Atmel Starter Kit hotline:

Telephone Number:

(44) 1970 621 049

Fax Number:

(44) 1970 621 040

Email:

stk300_support@atmel.com