Operating Procedures (Fixed Temperature Operation) - Yamato IC103C Manual

How to start fixed
temperature operation
MEASURED TEMP.
HEATER
RUN
設 定 温 度
MEASURED TEMP.
HEATER
RUN
SET TEMP.
TIMER
SUB MENU
MEASURED TEMP.
HEATER
RUN
SET TEMP.
TIMER
SUB MENU
When you want to correct
setting errors or change
settings
① When you want to lower the set temperature during fixed temperature
operation, note that it takes some time to reach the reset temperature since the
unit has no cooling capacity.
② Immediately after operation has been stopped, the temperature in the chamber
Caution
is around the set temperature. Operation stop refers only to machine stop and
time needed for decreasing the emperature in the chamber is not considered.

Operating procedures (fixed temperature operation)

1.Turn the power switch ON. (Turn the power switch to
"ON.")
When the power switch is turned ON, the intial values will
be displayed for about four seconds, then the initial
screen will appear and the current chamber temperature
and the previous set temperature are displayed on each
of the indicators.
℃
Measured temperature screen: Displays the current
chamber temperature
Set temperature screen: Displays the previous set
temperature
2. Setting the temperature
Set a temperature using the ▼▲ keys.
℃
RUN
STOP
3. Starting operation
Press the RUN/STOP key longer.
Fixed value operation will start and the RUN lamp and the
℃
HEATER lamp come on.
RUN
STOP
4. Stopping operation
Press the RUN/STOP key longer.
Operation stops, the RUN lamp goes off and the screen
switches to the initial setting screen.
When you want to change settings, press the ▼▲ keys on
the current screen to enter the setting mode where you can
change settings. Blink stops three seconds after three
seconds after change and setting is completed.
4. Operating procedures
19