Installation Procedures・Precautions - Yamato IC103C Manual

(1) Transportation of the product
・Lift and transport the model IC403C/403CW/413C/413CW/603C/613C by at least two people.
*Take care for protrusions on the unit.
・Move the model IC803C after push two
stoppers up to unlock the casters on the
front side of the main unit as shown in
the figure right.
the four points move smoothly before
trying to move the unit.
* Note that moving the unit over a bump
may give an excessive impact to and
break the casters.
such a bump, move the unit by lifting it
by at least two people.
(2) Select an installation site.
Make sure that four caster wheels for right, left, front and rear securely rest on a flat
surface as well as there is no loosened part or inclination of the unit and push down the
caster stopper to lock for the model IC803C.
(3) Install shelf boards.
・The lowest shelf board has been secured with screws at the time of shipping from the
factory.
adjusting
2. Before operating the unit
Make sure casters at
Where there is
Shelf pillar
Shelf clamp
Flow
plate
Shelf board
Installation procedures・precautions
Unlock
Lock
Screw
Screw
7
Stopper