Useful Functions (Calibration Offset Function) - Yamato IC103C Manual

Economy incubator

Hide thumbs Also See for IC103C:

Manual (45 pages)

Table Of Contents

Table of Contents

Using the calibration offset

function

MEASURED TEMP.

HEATER

RUN

SET TEMP.

TIMER

④

SUB MENU

③

Calibration offset function compensates any differences

between the target temperature in the chamber and the

control temperature of the controller (sensor temperature.)

The function can compensate in parallel to either plus or

minus side for the whole temperature band of the unit.

The lock can be set or released with the SUB MENU keys.

The temperature is set at "0" on shipping from the

factory.

① Start operation at the target set temperature and confirm

the temperature in the chamber with a temperature

recorder after temperature has stabilized.

② Confirm the difference between the set temperature and

℃

that in the chamber.

③ Press the TIMER key (SUB MENU key) long to enter the

RUN

sub menu mode.

STOP

Press the TIMER key (SUB MENU key) several times to

select the characters cAL

calibration offset function.

④ Enter the difference between the set temperature and

the temperature in the chamber using the ▼▲ keys

and press the TIMER key (SUB MENU key) long to exit

the sub menu mode. (When you want to set the key

lock function, proceed to character selection process for

the key lock function without pressing the TIMER key

(SUB MENU key) long. ）

4. Operating procedures