System Stand, 24R088; Caster For Stand, 120302; Adapter Plate, 24R083 - Graco InvisiPac Tank-Free HM25 Instructions - Parts Manual

Accessories

System Stand, 24R088

Use the stand to mount the system at eye level. When the
system is mounted on the stand, the ADM is 45 in. (1.14 m)
above the bottom of the stand.
Ref Part Description
1001 --- STAND
1002 112395 SCREW flange head cap
1003 112958 NUT, hex, flanged
System Stand Installation
1. Place stand (1001) in desired location.
2. Use bolt holes to bolt stand in place.
3. Place system on stand.
4. Use screws and nuts to secure system to stand.

Caster for Stand, 120302

Caster with friction post mounts directly to sys-
tem stand using no extra hardware. Four
required. Casters raise stand an additional 4.25
in. (108 mm).
98

Adapter Plate, 24R083

Use this adapter plate to install InvisiPac in place of an
existing hot melt applicator system.
Bolt Hole Dimensions
A
B
C
1002
1001
1101
1003
1102
1103
Ref
1101
1102
1103
1104
ti20985a
Adapter Plate Installation
Qty
1
1. Remove existing hot melt applicator system.
3
2. Use six screws (1102) and six nuts (1103) to secure
3
3. Align the InvisiPac system with the bolts on the adapter
4. Use the remaining three nuts (1103) to secure the Invi-
5. Use elbow fitting (1104) to install system air inlet
9.8 in. (249 mm)
14.843-15.157 in.
(377.0-385.0 mm)
17.003-17.317 in.
(431.9
-439.9
Part Description
--- PLATE, adapter
112395 SCREW flange head cap
112958 NUT, hex, flanged
121283 FITTING, elbow, 45 degree
adapter plate (1101) through the existing holes from the
previous system.
plate (1101) then place onto the adapter plate (1101).
siPac system to the adapter plate (1101).
filter (A, not included with kit).
C
B
A
1104
A
ti21918a
Qty
1
6
9
1
3A2347ZAA