Fujitsu AUU7RLF Design & Technical Manual page 129

7. Press the
/
emitted from the indoor unit when the signal is received correctly. If wrong code is set, no beep
sound will be emitted.
NOTE: Press
button within 30 seconds after pressing MODE button.
/
For the function details, refer to Chapter 14-5.
8. Exit the function setting mode by pressing the RESET button.
 Setting up each indoor unit
Repeat step from 1. to 8. to set up each indoor unit. If the custom code is other than " ", steps from
1. to 2. and 8. need to be performed.
14-2. Indoor unit (setting by wireless remote controller)
button once to transmit the function setting information. 2 short beeps will be
2 short beeps
"Function details"
RESET
- 123 -
on page 134.
14. Function settings