Function Settings; 14-1.Indoor Unit (Setting By Jumper Wire) - Fujitsu AUU7RLF Design & Technical Manual

14. Function settings

To adjust the functions of this product according to the installation environment, various types of
function settings are available.
NOTE: Incorrect settings can cause a product malfunction.
14-1. Indoor unit (setting by jumper wire)
NOTE: This setting is necessary only for slim duct type.
¢ Component location
¢ Jumper wire setting
 Drainage function setting (JM1)
JM1
Connect
Disconnect
 Auto louver grille setting (JM2)
When optional Auto louver grille kit is attached, set this setting to "Valid".
JM2
Connect
Disconnect
 Fan delay setting (JM3)
JM3
Connect
Disconnect
14-1. Indoor unit (setting by jumper wire)
JM3
JM2
JM1
Function
Enable
Disable
Function
Disable
Enable
Function
Disable
Enable
- 113 -
Factory setting
♦
Factory setting
♦
Factory setting
♦
14. Function settings