Fujitsu AUU7RLF Design & Technical Manual page 117

¢ Installation
1. Remove the insulation of the remote controller cable.
2. Insert the flat-blade screwdriver and remove the front case and rear case by twisting it
slightly.
3. Install the rear case to the wall, box, etc. with 2 screws (M4 × 16 mm). Fix the 2 screws in
either horizontal or vertical position.
A. When mounting on the box:
Attach the case after leading the cable.
B. When the cable is along the wall:
• Mount the rear case on the wall.
• Remove knock out hole for cable routing in the front case.
CAUTION
When connecting the remote controller cable, take measures to prevent the water or in-
sects coming into the remote controller through the cable, such as to provide the trap or
close the hole for cabling with the putty.
4. Configure the DIP switch setting with referring Chapter 14-8.
page 142.
13-5. Central remote controller (UTY-DMMUM: Optional part)
2-3/16 (55)
1-3/4 (45)
1-3/16 (30)
5/16 (8)
5/16 (8)
5/16
( )
8
Hooks (2 places)
Flat screwdriver
Remote controller cable
Box
Rear case
Putty
Putty
Trap
- 111 -
Unit: in (mm)
1. 12V (Red)
2. Signal (White)
3. COM (Black)
Rear case
Front case
Screws
Trap
Putty
Trap
"Central remote controller" on
13. Remote controller