Fujitsu AUU7RLF Design & Technical Manual page 118

5. Connect the cable to the terminals on the front case. Fix the cable together with the sheath
by using the cable tie. Cut off the excess cable tie.
1. 12 V (Red)
2. Signal (White)
3. COM (Black)
CAUTION
• Be careful to avoid breaking the cable by over-tightening the binder.
• When connecting the remote controller cables, do not over-tighten the screws.
6. Attach the front case.
• Adjust the upper part of the front case first, then insert the front case until it clicks.
• When inserting the front case, do not pinch the cable.
CAUTION
Insert the front case firmly. If improperly attached, it will cause the front case to fall off.
13-5. Central remote controller (UTY-DMMUM: Optional part)
Tightening torque
Terminal screw
Front case
Good Prohibited
- 112 -
7 to 10 lbf • in (0.8 to 1.2N • m)
Cable tie
Remote controller
cable (sheath)
Good
2 mm
Prohibited
(1/16 in)
Click!
Prohibited Prohibited
Hole for binder
Prohibited
13. Remote controller